Owner's manual

The LDX-3A requires three connections.

1. Transducer

2. Mains power supply.

3. Output signal, voltage or current.

A small hole should be made in the grommet prior to passing the wires through. If a screened cable is to be used, an

EMC cable gland is recommended.

For best performance in electrically noisy environments, the case of the LDX-3A should be connected to a local earth.

This can be achieved via the mounting bracket. This earth connection is not a safety earth, but is part of the overall

electrical screening scheme.

The wiring layout arrangements are similar for LDX-3A fitted with EMC glands and screened cable.

0V +VE

V OUT 0V I OUT

COARSE GAIN

FINE GAIN

COARSE

OFFSET

-VE

+VE

10V

FINE OFFSET

10K

- -

|F|

- -

DIV 2

G BK W R B

OUTPUT

POWER

1 2 3 4 5 6 (7)

FREQ

(ON)

(OFF)

NULL

4.3: Electrical Connections

4.0: Installation (continued)

M-1633/0905

LDX-3A