Owner's manual

LDX-3A

5.0: Setting up the Transducer and LDX-3A

M-1633/0905

The LDX-3A may be set-up with output signals anywhere within a ±10 Vdc or ±20 mA range. Typical outputs are ±10

Vdc, ±5 Vdc, 0-10 Vdc and 4-20 mA. These procedures apply to voltage and current output.

Voltage and current output are available at the same time, although they cannot be individually adjusted. Either voltage

or current should be chosen as the calibration reference.

All outputs use 0V signal as the signal reference.

A list of standard link settings is available, see section 5.2.

CAUTION:

During installation and adjustment, the top of the enclosure has to be removed for access to user adjustments. At this

time, standard ESD handling precautions for electronic equipment should be followed.