Owner's manual

LDX-3A
4.0: Installation
6
M-1633/0905
The LDX-3A may be mounted in a variety of ways and in any attitude. Ensure that there is enough space for the cover
to be removed to allow for internal adjustments. Space should also be allowed for the transducer connector, EMC
glands (if fitted) and cabling. It is recommended that the LDX-3A case be connected to earth or chassis. This earth
connection is not a safety earth, but is part of the overall electrical screening scheme.
The power supply may be mounted in any position. The power supply is for indoor use only and must be protected from
fluids. Ensure that the power supply can be disconnected from the mains. This can be by removing the plug from the
power supply itself, or by disconnection from the mains source. Also ensure that the mains lead cannot be accidentally
disconnected.
4.1: Mounting
Underside Mounting Top-Side Mounting
Note: If replacing
LDX-3A MKI a
retrofit mounting
kit is available if
repositioning holes
is not possible.