User Manual
7 8
oPeRAtInG AnD CLeAnInG PRoCeDURe
Removing/installing the container guide pin & housing plug
• Unplug the drink mixer.
• Hold the container guide by the indents on each side and pull straight down.
• Press the retainer clip and slide the guide pin out of the guide.
• Reverse the above steps to reinstall making note of the correct orientation.
Care and cleaning
• Place a drop of detergent and 1 cup of water into the container.
• Position the container into the container guide and mix on low speed for
5 seconds.
• Empty and rell with clean water and repeat for 5 seconds to rinse.
• Remove the container guide and wash with hot soapy water, then rinse.
• Clean the housing with a damp soapy cloth.
NOTE: Do not spray or submerge the mixer. Resulting water damage will not
be covered under warranty.
Press