installation and operating instructions OG62XA Cooktop
Dear customer, We thank you and congratulate you on your choice. This new carefully designed product, manufactured with the highest quality materials, has been carefully tested to satisfy all your cooking demands. We would therefore request you to read and follow these easy instructions which will allow you to obtain excellent results right from the start.
CABLE-CLAMP be required, it will be necessary to interpose an omnipolar switch with minimum aperture between the 3 mm. contacts, dimensioned to bear the plate load and it must follow the standards in force (the yellow/green earth cable must not be interrupted by the switch). The plug or omnipolar switch must be easily reached on the installed equipment.
Fig. 1a 4 INSTRUCTIONS FOR THE INSTALLER Installation These Instructions are for the qualified technician, as a guide to the installation, adjustment and maintenance, according to the laws and standards in force. Any of these operations must always be carried out when the appliance has been disconnected from the electric system. Installation (Gas) This appliance is not provided with a combustion product discharge.
Fig. 5 WARNING: CRYSTAL HOBS DO NOT TIGHTEN SCREW ‘A’ EXCESSIVELY, ONE TURN MAX WILL BE SUFFICIENT, AFTER CORRECTLY FITTING SHAFT ‘B’ INTO PLACE, AS SHOWN NOT BE SUBJECTED TO STRAINS CAUSED BY UNEVEN SUPPORTING SURFACES. IN THE PICTURE. ENSURE THAT THE SUPPORTING SURFACE IS PERFECTLY EVEN. FIT THE APPROPRIATE EXPANDED SEAL. CRYSTAL HOBS MUST 1 2 3 commutator 10 - 11 7-8 9 - 10 1-2 3-4 5-6 energy regulator medium high slight mild slow heat intensity melting of fats etc.
Vitroceramic Heating elements Electrical plates (Figg. 2-3-1a-1b). Rotate the knob towards the position required for cooking and bear in mind that the higher the number, the higher the heat output. See table "use of electrical plates". The pilot light on the stove panel level signals that the plate is "on". Some types of pilot lights will maintain some slight luminescence even after disconnection. That is quite normal. N.B.