User Manual

TROUBLE SHOOTING
REPLACING THE BULBS
1. Switch the range hood off and disconnect from the
mains power.
2. Open the aluminium filter.
3. Unscrew the light bulb carefully and replace it
with a similarly rated halogen light bulb (230V E14 base
28W MAX).
4. Replace the aluminium filter.
CLEANING
SAFETY PRECAUTION
Before cleaning your range hood or performing any maintenance, please ensure that the range hood is
turned off at the power point.
Do not use abrasive cleaners to clean the range hood. The use of warm soapy water and a cloth are
recommended. Ensure that the range hood is cleaned regularly, as a build-up of grease and fat may
occur otherwise.
The filters on the range hood must be cleaned regularly to maintain efficiency, and prevent grease
build up. It is recommended that this is undertaken every 4 – 6 weeks, depending on frequency of
use.
The filters can be cleaned with warm soapy water or a cloth, or they may be washed in a dishwasher. If
washed in a dishwasher, discolouration may occur to the mesh and frame.
Cleaning of the range hood must be performed as described above, otherwise there is a possibility of a
fire hazard due to grease and fat build up.
If the range hood is fitted with charcoal filters (for re-circulating) it is recommended that the filters be
changed every 3 – 4 months. Filter replacement will ensure correct function of the range hood, and
ensure that the air being re- circulated back into the room is clean.
Fault
Possible Cause
Solution
Light on, but
motor does not
work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact Everdure Service.
Motor failed
Contact Everdure Service.
Light does not
work, motor
does not work
House fuses blown
Reset/Replace fuses.
Power cord loose or disconnected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage
One way valve and the air ventilation
entrance are not tightly sealed
Take down the one way valve and seal
with sealant.
Leakage from the connection of U-shaped
section and cover
Take U-shaped section down and seal.
Lights not
working
Broken/Faulty globes
Replace globes as per this instruction.
Insufficient
suction
The distance between the range hood and
the gas top is too far
Refit the range hood to the correct
distance.
The Range hood
inclines
The fixing screw not tight enough
Tighten the hanging screw and make it
horizontal.
NOTE: Any electrical repairs to this appliance must conform to your local, state and
federal laws. Pleas
e contact the service centre if in any doubt before undertaking any of
the above.
Always disconnect the range hood from the power source when opening the range hood.