Instructions for the Use and Care and Installation of ORW6XA ORW9XA Wall Canopy Rangehoods
CONTENTS 1 2 3 4 5 6 7 8 Notice Features Installation Safety Warnings Operation Instructions Maintenance Troubleshooting Specification It is important that you retain these instructions, proof of purchase as well as other important documents about this product for future reference. Due to continual product development, Omega reserves the right to alter specifications or appearances without notice. Dispose of packaging responsibly – recycle where facilities are available. (1) NOTICE 1.
(2) FEATURES 1. The cooker hood uses high quality materials, and is made with a streamlined design. 2. Equipped with a high power electric motor and centrifugal fan, it produces strong suction with low noise, and features a non stick grease filter which is easy to clean. 3. The isolated low voltage (12 volt) circuit board control, means the halogen lights are brighter and safer than incandescent alternatives. 4.
(3) INSTALLATION (Cont.) 3.1 The cooker hood should be placed at a distance of 65-75cm from the cooking surface for the best effect. See Pic 1. 3.2 Install the hook in a suitable place once the installation height is fixed, and keep it vertically aligned. The fixed position of the inside chimney bracket determines the location of the chimney. 3.
(4) SAFETY WARNINGS This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Young children should be supervised to insure that they do not play with the appliance.
(5) OPERATION INSTRUCTIONS The re-usable aluminium grease filters supplied with this rangehood should be cleaned every month or so to avoid grease build-up. To remove the grease filter, release the locking mechanism at the front of the filter, and lower the filter slightly to unhook it at the back. Whilst the filter is removed, clean off any residual grease from the housing to avoid fire risk. When replacing the grease filters, ensure that the locking mechanism is facing down.
SPEED ADJUSTMENT - See pictures 1. Push ‘Stop’ button, and the motor will stop. 2. Push the ‘Low’ button, the buzzer will buzz once, and the motor runs at low speed. 3. Push the ‘Mid’ button, the buzzer will buzz once, and the motor runs at mid speed. 4. Push the ‘High’ button, the buzzer will buzz once, and the motor runs at high speed. 5. Push the ‘Light’ button and the two lights will come on. Push it again and the light will turn off.
(6) MAINTENANCE 6.1 Cleaning the grease filter mesh The filter mesh is made of high-density stainless steel. Please do not use corrosive detergent on it. Keeping this filter clean will keep the appliance running correctly (at least every 4-6 weeks). Please strictly follow the guidelines below. Method 1: Place the mesh in 40 - 50 DegC clean water, add in a small amount of detergent, and soak for 2 - 3 minutes. Wear gloves, and clean with a soft brush.
(7) TROUBLESHOOTING Fault Cause Solution The fan is blocked Light on, but motor does not work Light does not work, motor does not work Oil leakage Shake of the body Insufficient suction The machine inclines The capacitor damaged Remove the source of the blockage Replace capacitor The motor jammed and Replace motor bearing damaged A smell coming from the Replace motor motor Beside the above mentioned, check the following: Light damaged Replace lights Power cord loose Take to authorised servic
(8) SPECIFICATIONS Rated Input Rated Power Lighting Power Motor Power Air tube diameter Air output ORW9XA ORW6XA 220V-240V, 50Hz 230W 20W X 2 (halogen capsule lamp) 190W 150MM 730m3/h 705m3/h 9