Engineering Inc. User's Guide Remote Control

9.5 Remote Commands and Error Codes

The following tables list all commands, and their descriptions, that

are accepted by the calibrator.

Table 5: Common Commands

Command Description

*CLS (Clear status.) Clears the error queue.

*IDN? Identification query. Returns the manufacturer, model

number, and firmware revision level of the Calibrator.

*RST Resets the calibrator to the power up state.

Table 6: Calibrator Commands

Command Description

DAMP Turns Damp on or off.

DAMP? Returns if DAMP is on/off

DISPLAY Turns on/off the displays specified in the command

DISPLAY? Returns which displays are on/off

FAULT? Returns the most recent error code

ERROR_LOOP Turns loop power on or off in percent error mode

ERROR_LOOP? Returns the current state of loop power in error mode

ERROR_MODE Turns percent error mode on or off

ERROR_MODE? Returns whether percent error mode is on or off

ERROR_PORT Set the pressure port for percent error mode

ERROR_PORT? Returns the pressure port for percent error mode

FUNC Sets the display mode as specified in the command

FUNC? Returns the current mode of the upper, middle, and

lower display

HI_ERR Sets the 100% of span limit for percent error mode

HI_ERR? Returns the 100% of span limit for percent error mode

LOCAL Returns user to manual operation of the calibrator

LOCKOUT Locks out the keypad of the calibrator in remote opera-

tion

LO_ERR Sets the 0% of span limit for percent error mode

LO_ERR Returns the 0% of span limit for percent error mode

PRES_UNIT Set the pressure unit for the indicated display

PRES_UNIT? Returns the pressure from the indicated display

REMOTE Puts the calibrator in remote mode