Products, Inc Recording Equipment User Manual
6 - 19
6. SET MODE
6.9 Setting Messages (MSG)
The following setting enables you to set the messages. Up to five messages can be set,
each of up to 16 characters. Printing out messages can only be done with the use of the
remote control option (-R), with which your recorder must be equipped. Messages can
not be printed out without this option.
Note that the printing of the messages will not be done when the chart speed is faster than
1500 mm/h (Pen model) or 100 mm/h (Dot-printing model) or when recording is OFF.
To set a message, proceed as follows:
Key operation Indication Discription
Press the [DISP] key for three seconds to enter the SET mode.
Select the [ ] display using the [ ] key, and press the
[ENT] key.
The display which appears will prompt you to specify which
message you want to set. Up to five messages can be set. Use
the [ ] key to specify message number and press the [ENT]
key.
The maximum sixteen characters of the message can be set by
the described code (Example is given in parentheses).
corresponding code of the character (B)
sequential number of the character
you are setting (2nd)
The code number can be selected using the [ ] key. After
setting both numbers of a code, press the [ ] key and the
sequential number of the to be set character will fo go up one.
After setting, press the [ENT] key.
[ ] is diplayed and the setting is completed. Press the
[ENT] key to set another message; or press the [DISP] key for
three seconds to return to the OPERATION mode.
Table of characters codes.
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
012
#
%
(
)
*
+
–
.
/
3
0
1
2
3
4
5
6
7
8
9
˚
4
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
5
P
Q
R
S
T
U
V
W
X
Y
Z
µ
Ω
6
a
b
c
d
e
f
g
h
i
j
k
l
m
n
o
7
p
q
r
s
t
u
v
w
x
y
z
8
Ω
S
P
NOTE • If your recorder is equipped with the -R option, and you
want them to be triggered by remote control, the
messages must be assigned to the -R terminals.
• If you press the [ESC] key in the middle of setting, the
indication returns to the [ ] and already set data will
be aborted.
S/P means ‘SPACE’.
DISP
ESC
3 sec
3 sec
DISP
ESC
PRINT
FEED
PRINT
PRINT
CH UP
CH UP
CH UP
CH UP
6.9 Setting Messages (MSG)