SHDH, SSDH series SEPDH series SEPDH, SHDH, SSDH SERIES M-4305/0511 PN: 11663-01 Rev A Silicone Rubber Drum Heaters
TABLE OF CONTENTS Introduction................................................................. 2 Safety Alert Symbol.................................................... 2 Important Safety Instructions….................................. 3 Prior to Installation...................................................... 4 Installation of Heater................................................... 4 Mounting of Temperature Sensor................................ 5 Adjustment of Temperature Set-Point...................
ADJUSTMENT OF TEMPERATURE SET-POINT IMPORTANT SAFETY INSTRUCTIONS Agency Approvals SEPDH series 1. Remove the two screws securing the metal plate opposite the temperature sensor. SHDH and SSDH series A person who has not read and understood all installation instructions is not qualified to install this product. 2. Remove the metal plate to expose the low and high limit set-point controls. 3. Adjust the high and low temperature set-points to an appropriate level for the environment.
PRIOR TO INSTALLATION INSTALLATION OF HEATER Read and understand this entire manual before operating this electric heater. 1. Check for suspected damage to the heater like rips, punctures, etc. 2. Verify surface to be heated is free from all sharp edges, weld splatter, rust, oil, etc. 3. Check that the desired placement of the heater will not cause damage to the heater through impact shock, vibration, ambient temperature, or by neighboring moving parts. 4.
