Owner's manual

Figure 2-5. Laser Sighting Accessory, OS100-LS

Figure 2-6. Laser Warning Label

2.3.2 Laser Sighting Accessory Operation

The laser sight accessory screws onto the front of the sensor head. This accessory

is only used for alignment of the sensor head to the target area. After the

alignment process, the accessory has to be removed from the front of the sensor

head before temperature measurement.

The laser sight accessory is powered from a small compact battery pack

(included with the accessory). Connect the battery pack to the accessory using

the cable provided. Aim at the target, and turn on the battery power using the

slide switch on the battery pack. Adjust the sensor head position so that the laser

beam points to the center of the target area. Turn off the battery pack, and

remove the laser sighting accessory from the sensor head. See Fig.2.5 for

reference.

OUTPUT <1 mW, WAVELENGTH 630-670 nm, CLASS II (2) LASER 

PRODUCT. COMPLIES WITH FDA 21CFR 1040.10 & EN60825-1/11.2001

LASER RADIATION - DO NOT STARE INTO BEAM



LASER RADIATION DO NOT STARE 

INTO BEAM OR VIEW DIRECTLY WITH 

OPTICAL INSTRUMENTS. CLASS 2 

LASER PRODUCT.

®

CAUTION

AVOID EXPOSURE. LASER 

RADIATION IS EMITTED 

FROM THIS APERTURE.

LED LASER

POWER

INDICATOR

LASER WARNING LABEL

SENSOR HEAD

LASER BEAM

DC POWER JACK

POWER CABLE

SWITCH

ON/OFF

BATTERY PACK

POWER SUPPLY

50.8

(2.0)

(.75)

38.1

(1.5 )

Dimensions mm (in.)

2-4

Hardware