Owner's manual

• Never operate your wireless device or receiver outside the recommended

environmental limits specified in this manual.• Never operate your

wireless end device or receiver in flammable or explosive environments.

• Never use your wireless end device or receiver in medical, nuclear or other

dangerous applications where an interruption of readings can cause

damage or harm.• Never operate your end device or receiver with any

other battery or power source than what’s specified in this manual or on the

battery compartment label.

• No co-location with other radio transmitters is allowed. By definition, co-

location is when another radio device or it’s antenna is located within 20 cm

of your end device and can transmit simultaneously with your end device.

• Never install end devices within 20 cm or less from each other.

• Never use your end device as a portable device. Your unit has been designed

to be operated in a permanent installation.

• Never install and/or operate your end device closer than 20 cm to nearby

persons.

• Never operate your end device with any other antenna than what is supplied

or listed here in this manual for approved use.

4.6 Determining and Maximizing Range

The available maximum range specified for the wireless Series system in this

manual is only achievable under optimum installation conditions. Mounting

height, obstructions in your “Fresnel Zone” and ambient conditions can cause a

decrease in signal strength resulting in a shorter range between your transmitter

and receiver unit. The following recommendations will help to improve the

range of your wireless system.

Position your receiver in a central location

When multiple transmitters are in operation, position your receiver unit in a

central space if possible in equal distance to each connector transmitter.

Figure 4-3. Determining Maximum Range

System Operation

CONTROL ROOM

MANUFACTURING AREA

STORAGE ROOM

OFFICE

TRANSMITTER

RECEIVER

4-4