Owner's manual

Introduction

1-1

Section 1 - Introduction

Please read this manual completely before installing and operating your wireless

End Device and receiver system. It’s important read and follow all notes,

cautions, warnings and safety precautions before operating this End Device.

“End Device” referrers to your transmitter unit.

1.1 Precautions

• This device is not designed for use in any medical or nuclear applications.

• Do not operate this device in flammable or explosive environments.

• Never operate with a power source other than the one recommended in this

manual.

• This device has been designed for dry, moisture free indoor applications only.

• Do not operate this device outside of the recommended use outlined in this

manual.

• No co-location with other radio transmitters is allowed. By definition, co-

location is when another radio device or it’s antenna is located within 20 cm

of your End Device and can transmit simultaneously with your End Device.

• Never install wireless End Devices within 20 cm or less from each other.

• Never install and/or operate your End Device closer than 20 cm to nearby

persons.

• Never use your End Device as a portable device. Your unit has been designed

to be operated in a permanent installation only.

There are no user serviceable parts inside your device. Attempting to repair or

service your unit may void your warranty:

1.2 Safety Warnings and IEC Symbols

This device is marked with international safety and hazard symbols in

accordance with IEC standards. It is important to read and follow all precautions

and instructions in this manual before operating or commissioning this device as

it contains important information relating to safety and EMC. Failure to follow

all safety precautions may result in injury and or damage to your device. Use of

this device in a manner not specified will void your warranty

IEC symbols Description

Caution, refer to accompanying documentation

EU’s Waste Electrical and Electronic Equipment

Compliance

Laser Symbol

Figure 1-1. IEC Symbols

NOTE: