Owner's manual

Introduction
1
1.4 Statement on FCC
1.4.1 FCC Marking
FCC ID: OUR-XBEEPRO IC #4214A-XBEEPRO
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1.) This device may not cause harmful interference. 2.)
This device must accept any interference received, including interference that
may cause undesired operation.
1.5 General Description & System Components
1.5.1 General Description
The UWXL Series Long Distance Industrial Wireless Transmitters are stand-
alone, rugged, battery powered, wireless transmitters that send their
measurements to a host receiver up to 450 m (1500') line of sight (LOS) away.
The UWXL transmitters are designed for a variety of applications, including
temperature (RTD or thermocouple), infrared temperature, relative humidity,
process transducers with standard voltage or current outputs, flow (pulsed
frequency) as well as pH measurement. When activated, the transmitter will
send readings continuously at a pre-set time interval programmed by the user
during initial setup.
Each unit measures and transmits: Process value, Ambient Temperature, RF
Signal Strength and Battery Condition to the host. This information is then
displayed on the host PC screen in real time using the provided software. When
used with host receiver model UWXL-REC1, data from up to 48 wireless end
devices can be received and displayed simultaneously. Each receiver includes
free software that converts your PC into a strip chart recorder or data logger
allowing readings to be saved and later printed or exported to a spread sheet
file.
The UWXL-24-IR1 is a long distance wireless infrared temperature transmitter.
In addition to the standard UWXL features listed above, this model includes a
specially designed infrared sensor head. The miniature sensor head design (1"
dia. x 2.5" length) is ideal for measuring temperature in confined and hard to
reach places. The aluminum sensor head as well as the rugged electronic
housing (die cast aluminum) are NEMA-4 rated.
The sensor head is connected to the electronic housing via a 6 ft. shielded cable
as standard.
1-3