+ + + Product Contents + + VRT400 SERIES HE_OMEGA_VRT400_V.01.
IMPORTANT SAFEGUARDS Please read carefully before using and follow instructions to avoid injury. • To protect against risk of electrical shock or fire, do not put motor base, cord, or plug in water and keep them dry at all times. • Do not disassemble the base. All repairs should be made only by authorized personnel. • Check voltage to be sure that the voltage indicated on the name plate agrees with your voltage. • Close adult supervision is necessary when appliance is used by or near children.
IMPORTANT SAFEGUARDS Additional usage precautions: • Do not pre-operate before inputting food. Doing so may cause a normal squeaking noise. • Do not attempt to juice any hard materials, large seeds (seeds which can not be swallowed or chewed), pits, ice, or frozen foods. • If food gets stuck in the feeding tube, do not use anything other than the recommended pusher. • Do not use more than 30 minutes continuously (only meant for household use). SAVE THESE INSTRUCTIONS HE_OMEGA_VRT400_V.01.
Omega Juicer Manual For Household Use (Warranty Included) 1 2 3 4 Read “Precautions for safe use (Page 4)” carefully and use the appliance properly. Keep the manual within reach anytime and save it for future reference. Check if the voltage indicated on the base of the appliance corresponds to the local voltage before you connect the appliance. Any quality improvements are subject to change without notice.
With Omega’s own Slow Squeezing System and the Juice Cap as an additional mixing function, you can easily make personalized juice in rich tastes and flavors in full preserved valuable nutrients. 1. Much More Nutrients and Taste: Your own personalized juice Various mixed juice Not only enjoying single fruit juice but also adding various ingredients to your taste and health, you can simply make your own Omega juice.
GENERAL DESCRIPTION AND PARTS NAMES HOPPER PULP CONTAINER SQUEEZING SCREW JUICE CONTAINER COARSE STRAINER FINE STRAINER CLEANING BRUSH SPINNING BRUSH BOWL PUSHER BASE 02 l HE_OMEGA_VRT400_V.01.
SPECIFIC TERMS FOR PARTS 1. Hopper front triangle 2. Bowl triangle 4. Hopper rear part 5. Operating switch 3. Pulp outlet 6. Juice outlet 7. Juice cap 8. Power cord 9. Grip STRAINER* COARSE STRAINER The bigger holes in the strainer produce thicker juice when tender and soft fruits are extracted such as strawberries, kiwis and tomatoes. It is useful to extract more pulpy juice. FINE STRAINER The holes of the strainer are small.
PRECAUTIONS FOR SAFE USE All users of this appliance must read and understand this safety precaution before operating. WARNING Hazards or unsafe practices which could result in serious personal injury or death. CAUTION Hazards or unsafe practices which could result in minor personal injury or appliance damage. SIGN EXAMPLES This sign indicates contents that may cause risk of a fire or an electrical shock. Specific warnings are written in the sign.
WARNINGS AND CAUTIONS WARNING Hazards or unsafe practices which could result in serious personal injury or death. DO NOT PLUG IN OR UNPLUG WITH WET HANDS. It may cause an electric shock or an injury. DO NOT USE OTHER THAN 120V AC. It may cause an electric shock, a fire or an abnormal performance. If the voltage is different, it may shorten the life of the motor or cause a failure. PLUG THE POWER CORD CORRECTLY AND PUSH IT TIGHT IN A WALL SOCKET. It may cause an electric shock or a fire.
WARNINGS AND CAUTIONS NEVER DISASSEMBLE BOWL SET DURING OPERATION OR INSERT FINGERS, FOREIGN OBJECTS SUCH AS FORKS, SPOONS ETC. INTO FEEDING TUBE OR JUICE OUTLET. It may cause an injury, an accident or a failure. THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN) WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE BY A PERSON RESPONSIBLE FOR THEIR SAFETY.
WARNINGS AND CAUTIONS WHEN USING THE APPLIANCE, BE CAREFUL FOR A NECKTIE, LONG NECKLACE, SCARF ETC. NOT TO BE ENTANGLED INTO FEEDING TUBE. It may cause an injury, a failure or a breakage. PLACE THE APPLIANCE ON A FLAT AND STABLE SURFACE. It may cause an injury or a failure. 30minute DO NOT OPERATE THE APPLIANCE FOR MORE THAN 30 MINUTES AT A TIME. It may cause a motor failure due to overheating. Cool it down sufficiently about 5 minutes and operate it again.
SLOW JUICER ASSEMBLY STEP STEP STEP 4 Align hopper front triangle [ ▼] with bowl triangle [ OPEN ] first and turn it to clockwise until it clicks so that the hopper triangle [ ] aligned with bowl triangle [Close ]. 3 Make sure to press the screw down into the strainer as in STEP 2. The hopper does not close properly when the screw does not fit in completely. 2 Assemble the parts as following order: Bowl>Spinning Brush> Strainer. Make sure bowl triangle [ OPEN ] aligns with strainer triangle [ ▼].
SLOW JUICER ASSEMBLY IN DETAIL the hopper rear part with base completely as in below. 4 Align The hopper does not close properly when the parts are not assembled correctly. Hopper rear part 2,3 Assemble the parts in the order of bowl> spinning brush> strainer> squeezing screw> hopper (or assemble the spinning brush into the bowl then fit strainer bump in the bowl inner groove). Make sure all the triangles of bowl [ OPEN ], strainer [ ▼] and hopper [▼ ] are aligned in a vertical line.
HOW TO USE THE APPLIANCE REAR VIEW 2 Wash the fruits and/or vegetables and cut them into pieces that fit into the feeding tube. Place the suitable pieces into feeding tube slowly and press with a pusher. Use fresh fruits and vegetable for juicing as they contain more juice themselves.
JUICE CAP AND EXTRACTION PACKING JUICE CAP This is the cap of juice outlet in the bowl. Close the juice cap and fill up with juice in the bowl with various ingredients. You can easily make mixed fruit juice or vegetable juice. Juice cap 1 2 Open Juice cap 3 Close juice cap and press [ON] button to start. When juice starts filling up the bowl, you can mix banana, nuts, boiled sweet potato etc. and liquids such as milk etc. as well as vegetables and fruits like smoothies.
WHEN THE SCREW IS STOPPED DURING OPERATION (REVERSE/REV BUTTON) 1 Click [Reverse/REV] button in operating switches and stop the appliance. Stop 2 Press [Reverse/REV] button in operating switches for 3~5 seconds and release it. Repeat this process 2~3 times. Reverse is the button pushing ingredients upward. Reverse only works while the button is pressed and held. Once release the button, screw rotation stops.
IMPORTANT SAFEGUARDS IN USE ∙ Fruits with pits, hard seeds such as nectarines, peaches, mangos, apricots, plums and cherries must be pitted before juicing. ∙ Cut fibrous ingredients (water parsleys etc.) in small size like 3~4cm (1.5 inch) and place to the feeding tube. ∙ Drink the fruit juice or green vegetable juice immediately after you have extracted. If it is exposed to air sometime, the juice will lose its taste and natural value.
DISASSEMBLY, CLEANING AND CARE FIGURE IN ORDER 1 3 2 Juice outlet 14 l HE_OMEGA_VRT400_V.01.
DISASSEMBLY, CLEANING AND CARE 4 5 1. Ensure the motor stops completely and unplug the power cord. When unplugging the power cord, hold the head part of the power cord and unplug it. Do not touch the power cord with wet hands. 2. Hold the juice outlet and the hopper with both hands and lift them up from the base. 3. Disassemble the parts in reverse as below: 1) Unlock the bowl twisting to counterclockwise. 2) Take the screw out. 3) Remove the strainer.
BOWL DISASSEMBLY AND WASH juice cap packing bowl packing 1 Remove Juice Cap packing and bowl packing. Open juice cap first. Hold the bowl and juice cap with one hand and remove juice cap packing with the other hand like taking it off. When removing it, be careful not to drop the juice cap and bowl. It may cause damage to the juice cap. Remove the bowl packing like pinching and twisting it with two fingers. Extraction Packing the extraction packing at the bot2 Open tom of the bowl.
STERILIZATION AND EASY CLEANING SYSTEM STERILIZATION For sterilization, use baking soda or natural wash-up liquids only. You can thoroughly wash them immersing in the water diluted with one or two drops of baking soda or natural wash-up liquids for about 30 minutes. EASY CLEANING SYSTEM Open closing the juice cap, pour the water a while, open the juice cap and 1 After 2 After into feeding tube and operate the appliance. discharge the water.
SPINNING BRUSH DISASSEMBLY AND WASH 1 Spinning brush Silicone brush 2 3 Remove the spinning brush from strainer. Detach the silicone brush from spinning brush. As shown to the left, hold the outer part of silicone brush with your fingers and pull it out to the arrow direction. It is recommendable to remove it according to the above method. If pulling it by force, silicone brush may be torn or spinning brush may be damaged.
SPINNING BRUSH ASSEMBLY SPINNING BRUSH SILICONE BRUSH 1 Inner wing 1 Up (longer part) 2 Outer wing Brush groove Check the groove of the spinning brush and the direction of silicone brush. There are grooves to insert silicone brush in the spinning brush. Silicone brush has inner wing ❶1 and outer wing ❷2 . As shown to the left, let ‘inner wing’ face the spinning brush. Down (shorter part) 1 2 Insert the silicone brush into the spinning brush. According to the No.
BOWL PACKING ASSEMBLY 1 Hold the bowl packing like pinching. 2 Insert the bowl packing into the bowl hole. As shown to the left in a dotted circle, let the protrusion part on the bowl packing face upward and hold it like pinching with your thumb and index finger. Bowl packing 3 Insert the bottom of the bowl packing into the bowl hole and fully press it down. Do not insert whole part of bowl packing. The upper part of the bowl packing must be shown.
JUICE CAP PACKING ASSEMBLY 1 Hold juice cap packing as shown to the left. 2 Open the juice cap and insert the juice cap packing in. 3 Organize the packing to seal off completely. As shown to the left in a dotted circle, the hole must be visible when you hold. Juice cap packing Insert it in from the top to the juice cap. Be careful not to drop the bowl. If the packing is not completely sealed, it may cause juice leaking. l 21 HE_OMEGA_VRT400_V.01.
TROUBLESHOOTING Check the details below before contacting Technical Support for repair or service. If you need information or if you have a problem, please contact the local Customer Care Center. When applying for after sales service, check the manufacturer’s serial number or bar code. THE APPLIANCE DOES NOT WORK. Make sure the power cord is properly plugged in. Check the hopper is assembled properly. If the hopper has not been properly locked in place, the appliance does not work for safety reason.
APPLIANCE SPECIFICATIONS APPLIANCE STANDARDS PRODUCT NAME Omega Slow Juicer MODEL NAME VRT400 Series RATED VOLTAGE 120 V RATED FREQUENCY 60 Hz RATED POWER CONSUMPTION 150 W RPM (REVOLUTIONS PER MINUTE) 80 RPM CORD LENGTH 1.4 m이상 MOTOR Single-phase induction motor FUSE 250 V 10 A WEIGHT 6.01 KG (13.2 LB) OUTWARD DIMENSIONS Width 160 mm Length 218 mm Height 405 mm RATED OPERATING HOUR Less than 30 minutes l 23 HE_OMEGA_VRT400_V.01.
WARRANTY Product name Model name Manufacture’s serial number Date of purchase Supplier Customer name Address Important: To better protect your purchase, fill out and mail this form to a local distributor where you have purchased, and keep the original receipt. This certifies that the Omega Slow Juicer is warranted by Omega to be free from defects in material construction and workmanship.
MEMO l 25 HE_OMEGA_VRT400_V.01.
V.01 Copyright© All Rights Reserved by HUROM HE_OMEGA_VRT400_V.01.
