User's Manual

Getting Started

Emissions Testing

Before attempting to test vehicle emissions levels, ensure that the base station and

handset are fully charged (see ‘Power Management’, page 7) for remote operation.

For on-road testing if the base station batteries are low, connect the base station to

the vehicle supply cable (optional). With this configuration the batteries will not charge

but the supply to the base station is maintained.

OmiScan Gas emissions testing can be undertaken by using the handset separated

from, or in position on, the base station.

Handset Navigation

Press the ‘Power up’ buttons on the base station and then on the handset, the

handset screen displays the ‘Main Menu’ and lists the functions available:

• Gas Analyzer

• PC/USB Mode

• Settings

• Language

The handset will automatically start searching for the Bluetooth

Wireless

Technology address specific to the base station. The handset and the base station

are ‘paired’ together to prevent any interference or acquisition from other Bluetooth

Wireless Technology devices such as laptop PCs or mobile telephones. After a few

seconds an antenna icon will appear in the top LH corner of the screen indicating that

the Bluetooth

Wireless Technology link has been established. This icon will always

be displayed whilst the link is made.

The battery icon in the top RH corner reflects the charge status of the handset battery

pack.

NOTE: The battery icon will flash empty to indicate a low battery charge for either the

handset or the base station - see ‘Power Management’, page 7.

The Main Menu has four options:

• Gas Analyzer - Emission testing and analyzer system checks

• PC/USB Mode - Used for down loading test result and updating handset

MAIN MENU

Gas Analyzer

PC/USB Mode

Settings

Lang, Idioma

