Instructions / Assembly

ENGLISH

• 3 •

2. Screwwhitettingsintohousingcapbyhand.Useawrenchtotighten

rmly.DONOTOVER-TIGHTEN.Aboutonethreadshouldremainvisible.

NOTE: Ifusingmountingbracket,besuretoinsertttingsthroughbracket

beforethreadingintoltercap.

3. Measurelengthacrossassembledttingsandsubtract3inches.Mark

section of pipe to be removed.

NOTE: Approximately8-1/2incheswillberemoved.Usingapipecutteror

hacksaw, cut pipe and remove marked section. File or sand sharp edges

on remaining pipe.

4. Mark the ends of the cut pipe 1-1/2 inches from the end.

5. Alignlterassemblywithendsofpipe,makingcertainthe“FLOW”arrow

ispointedinthedirectionofyourwaterow.Itwillbenecessarytospread

endsofpipeaparttoinstalllterassembly.Insertoneendofpipeintothe

quick-connecttting.Firmlypushthepipeinuptothe1-1/2 inch mark on

the pipe. Insert second end of pipe into opposite side up to mark on pipe

(A) Turn on water supply. (B) Slowly turn handle counterclockwise

1/2turnonhousingtoallowltertollwithwater,(C) then depress red

pressure-relief button on top of cap to release trapped air.

(D) Opennearestfaucetandushcartridgefor5minutes.

6. Close faucet and check for leaks.

CAUTION

If water pipes are used to ground electrical systems,

appliances or phones, be certain to install a jumper wire. Contact a

qualiedelectricianwithanyquestionsaboutyourhome’s

electrical system.

1.5"