User's Manual

OMNIKEY® 6310 Smart Card Reader Installation Guide
2 © 2008 OMNIKEY GmbH. All rights reserved.
Introduction
This guide describes physical behaviour and conformities of the OMNIKEY® 6310, a
contactless smart card reader with optional SIM-sized contact interface.
To install the OMNIKEY® 6310 follow the steps described. For further information, contact
OMNIKEY support:
[e-mail]
Content
• Smart Card Reader
• Installation Guide
Find drivers and additional manuals for this reader and various operating systems at
http://www.hidglobal.com/Omnikey.
Overview
The OMNIKEY® 6310 is a PC-linked reader that reads 13.56 MHz (RFID) contactless
smart cards. Optionally, this reader is equipped with a contact interface, which
reads/writes to virtually any contact smart card.
The OMNIKEY 6310 is a USB plug-and-play device. To connect the reader with your
computer, plug the USB connector into your computers USB port.
When the reader is working, the LED illuminates blue. Consult the OMNIKEY User Guide
for driver setup, if the reader is not working.
For contactless operation, place the card on the reader. If a contact interface is available,
insert the contact smart card with the correct orientation.
When the reader is exchanging data with a card (reading or writing) the LED of the reader
will blink.
Specifications
Dimensions
Approx. 94 x 26 x 15mm / 3,7” x 1,02” x 0,59”
Weight
Approx. 17 gr / 0,59 oz
Operating Temperature
0°-55°C / 32°-131°F
Operating Humidity
10-90% rH
Composition
ABS
USB Connector Cable
TBD
Contact Interface Durability
10,000 Insertions
Meantime between Failure (MTBF)
500,000 Hours
Host Interface
USB 2.0 CCID (also supports 1.1)
Host Data Transmission Speed
12 Mbps (USB 2.0 Full Speed)
Power Supply
Bus powered