Installation Guide

10.0 SPEAKER MOUNT USER’S GUIDE
REQUIRED TOOLS
A. 5/32” hex wrench (supplied)
Drill bits:
B. Wood 5/32”
C. Drywall - ¼”
D. Masonry - 5/16” carbide tipped
E. Crescent or 7/16” (11mm) open end wrench
F. Phillips screwdriver
G. Electric drill
H. Hammer (masonry only)
GB
MOUNTING OPTIONS
Possibilités de montage
Posibilidades de instalación
Montagemöglichkeiten
Opzioni di montaggio
Montageopties
1. SPEAKER OPTIONS
A) ¼” 20 Threaded Insert C) Mounting Plate
B) Keyhole Insert D) Wood Speaker Without Threaded Inserts
Use 3/32” drill bit (supplied)
Maximum drill depth: ½”
2. CLAMP ASSEMBLY ORIENTATION
A) Wall Mount
A) Ceiling Mount
3. MOUNTING THE CLAMP ASSEMBLY
A) Mark Location
Mark mounting holes with pencil
B) Mounting onto Wooden Stud. Use 5/32” drill bit
Minimum mounting hole depth: 2” (51mm)
C) Drywall Mounting
Use ¼” drill bit
Insert anchor into hole
D) Mounting into Masonry
5/16” (8mm) carbide tipped bit and masonry or hammer drill.
Wear eye protection.
Minimum mounting hole depth: 2” (51mm)
Insert anchor into hole
E) Mount Clamp Assembly
Attach clamp assembly with supplied screws.
4. JOINING BALL SHAFT AND CLAMP ASSEMBLY
Open clamp assembly enough to accept ball.
“Pop” ball into the clamp assembly.
Set speaker to desired position.
Tighten clamp assembly until snug.
Note: Speaker weight must be fully supported
during the tightening process.
5. FINAL ADJUSTMENTS
Use tool to tighten in 1/2 turn increments.
Do not over tighten.
To change speaker angle, loosen tension screw,
re-position speaker, then re-tighten tension screw.
To rotate speaker cabinet, loosen jam nut, rotate
speaker into desired position, then re-tighten jam nut
PART#: 1002013