Installation Manual

AVIATOR UAV 200
Installation Manual
Document: 677-A0219_IM issue 1.4
COBHAM PUBLIC
Page 10 of 61
1. ABOUT THIS MANUAL
1.1 INTRODUCTION
This installation manual provides the general installation procedures for the AVIATOR UAV 200 and
configuration of the terminal once installed in the aircraft.
AVIATOR UAV 200 has been tested but not formally qualified to RTCA DO-160G specifications. As such,
Qualification Test Reports and other supporting documentation are not available.
NOTE: It is important that all safety requirements listed in the beginning of this manual are observed, and
that the system is installed according to the guidelines in this manual.
1.2 PURPOSE
The information, drawings and wiring diagrams contained in this manual are intended as a reference for
engineering planning only. It is the installer's responsibility to compose installation drawings specific to the
aircraft.