Installation Manual

AVIATOR UAV 200
Installation Manual
Document: 677-A0219_IM issue 1.4
COBHAM PUBLIC
Page 13 of 61
The terminal is designed to be internally mounted below a protective radome/dust cover or RF transparent
fuselage section. A soft radome/dust cover is fitted for the purpose handling and environmental protection.
The terminal has all the components of a traditional aeronautical SATCOM system namely a steerable
phased array Low Gain Antenna (LGA), High Power Amplifier (HPA), Diplexer/Low Noise Amplifier (DLNA)
with an ATCt resilient mode, and a Modem that manages the interaction with the satellite network,
modulation/demodulation functions as well as providing the user interfaces.
The remaining airframe requirements for terminal operation are limited to DC power, navigation data (for
antenna steering) and heat sinking or cooling into the aircraft structure or ambient environment.
LGA Antenna Array
RF Board
- HPA
- LNA
- Diplexer
Environmental Radome
Ground Plane
Mounting/Grounding/Cooling
User Interfaces
DC Power (14 or 28 VDC)
Serial Port (RS-232)
Serial Port (RS-232)
Ethernet (10Base-T)
Ethernet (10Base-T)
Reset Discrete (Open/Ground)
Modem Board
- Control &
Applications
- User Interfaces
- Radio Module
- Power Supply
Air Interface Aircraft Interfaces
Navigation Information
(via Ethernet/Serial Port)
Figure 3-2: AVIATOR UAV 200 Functional Overview Block Diagram
3.3 EXTERNAL INTERFACES
The AVIATOR UAV 200 has a single connector (Refer to Table 3-2) for all external electrical interfaces. See
Figure 3-3 for the connector layout and Table 3-4 for the Pin assignments for the external connector.
Multiple variations of a suitable mating connector may be constructed in order to facilitate specific customer
needs. Refer to Table 3-3 for the basic mating connector information.
Table 3-2: AVIATOR UAV 200 Connector Information
Reference
Part Number
Description
Manufacturer
J1
D221R34D56xx
34 Way, DMM Micro, Male
Nicomatic
Table 3-3: AVIATOR UAV 200 Mating Connector Information
Option
Part Number
Description
QTY
1
D222SP34D53
34 Way, Nicomatic DMM Micro, female connector
supplied with 24 – 28 AWG Crimp Contacts.
1
C13064-P
22 AWG, Crimp contact
Recommended for power input pins 1, 2, 18 & 19.
4
2
D222CP34D53
34 Way, Nicomatic DMM Micro, female connector
supplied with 22 AWG Crimp Contacts.
1