Installation Manual

AVIATOR UAV 200
Installation Manual
Document: 677-A0219_IM issue 1.4
COBHAM PUBLIC
Page 27 of 61
8. USING THE AVIATOR UAV 200
8.1 CONFIGURING THE TERMINAL
Having installed the AVIATOR UAV 200 System you must configure the terminal properly for use with the
current setup, and configure the correct navigational input.
Furthermore the interfaces have to be set up and configured to the specific aircraft installation and
application requirements. IP connections, network user groups and profiles for IP data usage including LAN
network management must be configured so the required applications run smoothly on the system. For this
purpose you use the built-in web interface Dashboard of the AVIATOR terminal.
Before you start configuring the AVIATOR UAV 200 make sure that the USIM is mounted
in the terminal. See Figure 4-1 for the location of the USIM.
Ensure that the USIM is activated and airtime is loaded.
8.1.1 Initial Configuration of the AVIATOR UAV 200
As a minimum, you need to set up the following parameters in the built-in web interface of the UAV 200
terminal:
1. On the Web Interface DASHBOARD verify that you have the latest AVIATOR UAV 200 software
version (see https://sync.cobham.com/satcom/, Cobham SYNC Partner Portal under Technical
Support -> Downloads). Verify also that the latest firmware is up to date. For more information
on the individual fields see Web Interface Dashboard on page 31.
Figure 8-1: Basic configuraiton of the UAV 200, step 1/5
2. Control Panel->Port Forwarding, configure the port forwarding addresses.
3. Note: If in a case where Port Forwarding is used simultaneously with the Transparent mode
feature, ensure that the port numbers configured are different in the Port forwarding configuration
compared to the Transparent Mode Configuration.