Installation Manual

AVIATOR UAV 200
Installation Manual
Document: 677-A0219_IM issue 1.4
COBHAM PUBLIC
Page 29 of 61
5. Enter the APN for the service provider for the Transparent serial port connection. This connection is
automatically connected once configured. Every time the terminal powers up, this connection is
automatically setup.
AVIATOR UAV 200 RS232 Proxy settings for Transparent RS232 mode. The proxy settings is
required to send the serial data to the destination computer. Enter the IP address and port number
for the destination computer. The Target packet payload is the target data packet size to be sent.
The Idle ticks trigger is the time in milliseconds after which the packet will be sent anyway even if it
has not reached the target payload size. The Static local port is primarily used if data has to be sent
back to the AUAV200 transparent mode RS-232 port.
Note: When data is sent from the Proxy Server to the UT, the Proxy Server IP address must be the
same as what is configured as Destination IP. If the Static port is set to zero the normal dynamic
port allocation will be set. Enter the IP address and port number for the destination computer. Set
the protocol to desired setting, either UDP or TCP. The Quality Of Service (QoS) of the connection
type is configurable using the Connection type drop down. Check the checkbox at the High priority
pool to send this user data over a High Priority buffer.
Figure 8-4: Configure RS232 Proxy and APN Settings, step 4/5