Installation Manual

AVIATOR UAV 200
Installation Manual
Document: 677-A0219_IM issue 1.4
COBHAM PUBLIC
Page 31 of 61
8.3 USING THE AT COMMAND INTERFACE
Primarily the AT Command interface will be used to send navigation data to the UAV 200 terminal. This is
required for antenna steering. The AT Commands can also be used to monitor and control the terminal
during operation. See the AT Command Reference document [3] for details on the supported commands.
8.4 WEB INTERFACE DASHBOARD
The web interface is built into the terminal and is used for operating, setting up and configuring the system.
You can access the web interface from a computer with a standard Internet browser.
The figure below shows the Home Page for the AVIATOR UAV 200 web interface. The default IP address is
192.168.0.1 . The different regions shown below in Figure 8-6 have different functions. These are:
1. Make a connection
2. Edit Connection Parameters
3. Terminal Status display
4. Position Information display
5. Status bar – Satellite receiver strength and Alerts
6. Go to Home Page Dashboard
7. Go to Control Panel Page
Figure 8-6: DASHBOARD Home Page
8.4.1 Check the connection to the web interface
To check whether you can connect to the web interface of the UAV 200 do the following:
1. Power up the AVIATOR UAV 200 terminal. Wait until the LED on the front panel shows the system is
ready.
 Status LED: Solid white.
2. Connect a PC to one of the Ethernet interfaces of the terminal using a LAN cable.
3. Open your browser and enter the IP address of the SBU. The default IP address is 192.168.0.1.