Installation Manual

AVIATOR UAV 200
Installation Manual
Document: 677-A0219_IM issue 1.4
COBHAM PUBLIC
Page 37 of 61
8.4.5 Control Panel
By Clicking on the icon on the bottom right corner of the DASHBOARD Main Page (see Figure 8-6) the
Control Panel page is displayed as shown below.
Figure 8-17: Control Panel
8.4.5.1 RS232
The AVIATOR UAV 200 has two serial ports to send user data or navigation data over the connection. The
Transparent Mode of operation is for sending user data and the AT Command Mode is used for sending
navigation data to the terminal.
Figure 8-18: RS-232 Mode Selection
Select the Operational Mode dropdown list to either Transparent Mode or AT Command Mode to
enable the RS232 serial port.
Set the RS232 serial port baud rate, number of data bits, start and stop bits and parity for the connection
using the dropdown list.
Note: Flow control is only available on RS232 serial port0. If flow control is required for the serial port
connection, this can be set using the Flow Control dropdown list.
Note: The RS232 serial port automatically creates a PDP context connection when it is enabled. Select
Port Not Used in the Operational Mode dropdown list if the RS232 serial port is not in use.