Installation Manual

AVIATOR UAV 200
Installation Manual
Document: 677-A0219_IM issue 1.4
COBHAM PUBLIC
Page 4 of 61
FCC REGULATORY INFORMATION
EQUIPMENT IDENTIFICATION:
Model
FCC ID
AVIATOR UAV 200
2AS39-AVIATORUAV200
RADIOFREQUENCY RADIATION EXPOSURE INFORMATION:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance of 50 cm between the radiator and your
body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
NOTICES:
1) This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
a) this device may not cause harmful interference, and
b) this device must accept any interference received, including interference that may cause
undesired operation.
2) Changes or modifications made to this equipment not expressly approved by Omnipless
Manufacturing (PTY) Ltd may void the FCC authorization to operate this equipment.
3) This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.