Manual

PasswordXXX
PrivateReload(③)On/Off
AllReloadOn/Off
Password(050)
PrivateReload
AllReload
Program
Play①
DMXReceive
SlaveReceiveSlaveReceive1,2,3
SequenceMaster/Standalone
MusicMusic/Standalone
DMXReceive
ChooseSlavePosition
RunSequence
MusicMode

SelectChase②
ChasePart1
Chase1~8Chase1
ChasePart2
Chase1~8Chase2
ChasePart3
Chase1~8Chase3
SelectandRunAuto
Program

EditChase②
Chase1ChaseTest
…Step01=SCXXX
Chase8Step64=SCXXX
Test
BeginningScene
EndingScene

EditScenes②
EditScene001Pan,Tilt…=XXX
~EditSceneFadeTime=XXX
250Scene=XXX
Time
DMXInput
InputManualScene
FadingTime
SceneTime
InputScenefrom
Controller

ScenesRecord
ScXX=>ScXX
AutoInputScenes


Connect

DMXAddressSetting
WiththisfunctionyoucanadjustthedesiredDMXaddressviatheControlBoard.
Select“DMXAddress“bypressingUporDown.
PresstheEnterbuttonthenadjusttheDMXaddressbypressingUporDown.
PresstheEnterbuttontoconfirm.

Light

MaxTemperature
With this function you can set the inside temperature at which the projector will automatically switch the lamp                 
off. Press Up or Down to select the maximum internal temperature between 80°C and 139°C. Internal               
temperatures below 90°C are not critical. 90°C and more should lead to the lamp being switched off after five                  
minutes.Pleasenotethattheoutsidetemperatureshouldnotexceed45°C.

Information

CurrentTimeInformation
With this function you can display the temporary running time of the device from the last power on. The display                   
shows“XXXX”,“X“standsforthenumberofhours.Thecounterisresetafterturningthedeviceoff.

FixtureLife
With this function you can display the running time of the device. The display shows “XXXX”, “X“ stands for the                   
numberofhours.

TemperatureNearLampTemp
WiththisfunctionyoucandisplaythetemperatureintheprojectorheadindegreesCelsius/Fahrenheit.

Fanspeed
Withthisfunctionyoucandisplaythecurrentfanspeed.Thedisplayshows“XXXX”,“X“standsforHz.
19 of 27