Manual

Procedure:
Theprojectorshouldbeinstalledoutsideareaswherepersonsmaywalkbyorbeseated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all installation
material and the projector. If you lack these qualifications, do not attempt the installation yourself, but instead use
aprofessionalstructuralrigger.Improperinstallationcanresultinbodilyinjuryand/ordamagetoproperty.
Theprojectorneedstobeinstalledoutofreachofpeople.
If the projector shall be lowered from the ceiling or high joists, professional trussing systems need to be used. The
projectormustneverbefixedswingingfreelyintheroom.
Caution: Projectors may cause severe injuries when crashing down! If you have doubts concerning the safety of a    
possibleinstallation,doNOTinstalltheprojector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector's
weight.
Theunitcanbeplaceddirectlyonthestagefloororriggedinanyorientationonatrusswithoutalteringits
operationcharacteristics(seethedrawing).
Thefixturebaseenablesmountingintwo
ways.
Foroverheaduse(mountingheight
>100cm),alwaysinstallanappropriate
safetybond.
Pleasenote:foroverheadriggingin
publicorindustrialareas,aseriesof
safetyinstructionsinthismanualneed
tobefollowed.Theoperatormustinform
themselvesonthecurrentsafety
instructionsandconsiderthem.
8 of 27