ORLAND FOLLOW PR-1211 This product manual contains important information about the safe installation and use of this projector. Please read and follow these instructions carefully and keep this manual in a safe place for future reference. PR LIGHTING LTD. Yingbin Road, Dashi Panyu, Guangzhou, 511430 China h t t p : / / w w w . p r- l i g h t i n g .
INDEX SAFE USAGE OF THE PROJECTOR 3 OPERATION 4 FITTING THE LAMP 5 MASTER/SLAVE SYNCHRO MODE 5 MAINTENANCE 6 KEEPING THE PROJECTOR CLEAN 7 TROUBLESHOOTING 7 TECHNICAL DATA 7 Please note that as part of our ongoing commitment to continuous product development, specifications are subject to change without notice. Whilst every care is taken in the preparation of this manual we reserve the right to change specifications in the course of product improvement.
SAFE USAGE OF THE PROJECTOR When unpacking and before disposing of the package check there is no transportation damage before using the projector. Should there be any damage caused by transportation, consult your dealer and do not use the apparatus. Keep the package well for your possible future transportation. The projector is for indoor use only, IP 20. Use only in dry locations. Keep this device away from rain and moisture, excessive heat, humidity and dust.
OPERATION Oralnd Follow has 4 channels and uses international protocol DMX 512. You can finish all operations via dedicated controller without using other controllers. When the power is switched on, the projector automatically starts to run the programmes of self test. After finishing these, the apparatus is ready for operation. HOW TO OPERATE THE DEDICATED CONTROLLER A (STOP button): Pressing this button and holding it, the light beam will become stronger and stronger.
FITTING THE LAMP Remove the cover by loosening a M4 knurled screw. Insert the lamp in the lamp-holder, and ensure the little bubble on the lamp is at a right angle (90°) to the beam path. Keep the lamp clean during installation. Reinstall the cover and tighten the M4 knurled screw. Note: The HMI series are high pressure lamps with external igniters ( ). Care should always be taken when handling these lamps. Always read the manufacturers "Instructions for use" enclosed with the lamp.
MASTER / SLAVE SYNCHRO CONNECTIONS Connect the controller’ s feamal plug to the first luminaire’ s input, and connect the first luminaire’ s output to the second luminaire’ s input via signal cable. Do not connect the second controller’ s cable with the second projector. The rest may be deduced by analogy are illustrated below. Now, you only use the master’ s controller to control the all projectors, and all the projectors linked will work synchronously.
KEEPING THE PROJECTOR CLEAN To ensure the reliability of the projector it should be kept clean. It is recommended that the fans should be cleaned every 15 days. The dichroic colour filters should also be regularly cleaned to maintain an optimum light output. Do NOT use any type of solvent on dichroic colour filters. Cleaning frequency depends on the environment in which the fixture operates: damp, smoke or particularly dirty surroundings can cause greater accumulation of dirt on the unit’ s optics.
PR LIGHTING LTD. Yingbin Road, Dashi, Panyu, Guangzhou, China Post-Code: 511430 TEL: 020-8478-1888 FAX: 020-8478-6023 P/N: 321020030 Last Revision: 18:12:2003 8/8 Orland Follow manual.