User Manual

3.5 VERIFY OPERATION
PI SA
Once the module has been installed and configured, per Sections 3.2 - 3.4, verify the module is operational
by viewing the status of the LED indicators. The table below provides a description for each LED indicator .
The Power LED indicates the module is receiving power from the chassis or power cord. The plug-in
modules has an LED indicator for each available power supply in the chassis (the 19-Module Chassis has
three, the 5-Module Chassis has two).
The Fiber Optic LEDs (“P1” and “P2”) indicate the fiber optic connections have been established. A
blinking LED indicates the presence of data.
Refer to Section 6.0, Troubleshooting Guide, for help in determining possible fault conditions.
PI SA
PI SA
LED Fu nction
"Legen d"
Color Off State
On / Blink in g Sta t e On / Blin k ing S t a t e
Power " Pwr" Amber No power On: Module has power On: Module has power
Power S upply Status
#X
Amber
Chassi s P ower
Supply not i nstalled
On: P ower available from
installed P ower Supply #X
Blinking: No power available
from i nstalled Power Supply #X
Not available on standalone
Port 1
Fi ber Li nk A ctivity
"P1"
Green No Fi ber Link
On: F iber li nk is active
Blinking: Receiving Fiber Data
On: Fiber link is active
Blinking: Receiving Fiber Data
Port 1
Half/Full Duplex
"FDX"
Green Half-D uplex On: Full-Duplex On: Full-Duplex
Chassis Management
Master/Slav e
"Msr/Slv"
Green
Chassi s S lave
Mode
On: Chassi s Master
Blinking: Operating i n OAM
Mode
Not available on standalone
Port 2
Fi ber Li nk A ctivity
"P2"
Green No Fi ber Link
On: F iber li nk is active
Blinking: Receiving Fiber Data
On: Fiber link is active
Blinking: Receiving Fiber Data
Port 2
Half/Full Duplex
"FDX"
Green Half-D uplex On: Full-Duplex On: Full-Duplex
Page 23