User Manual

4.3.3 SFP Information
The 2FXM module will provide general and specific information on the SFP. This information is best
viewed with SNMP management software. The following is the information available:
4.3.3.1 SFP A0 Information Display
This section displays fixed SFP Module information for the following areas.
• Identifier Values • Extended Identifier
• Connector Values • T ransceiver Codes
• Encoding Rules • Normal Bit Rate
• Link Length • Vendor Name
• Vendor OUI • Vendor Revision Number
• Laser W avelength • Options
• Vendor Serial Number • Date Code
• Diagnostic Monitoring Type • Enhanced Options
• SFF-8472 Compliance
4.3.3.2 SFP A2 Information Display
This section displays decoded SFP data collected for the following statistics.
• Measured Temperature • Measured Vcc
• Measured Bias • Measured Tx Power
• Measured Rx Power • Temperature High Alarm Setting
• Temperature Low Alarm Setting • Temperature High Warning Setting
• Temperature Low Warning Setting • Vcc High Alarm Setting
• Vcc Low Alarm Setting • Vcc High Warning Setting
• Vcc Low Warning Setting • Bias High Alarm Setting
• Bias Low Alarm Setting • Bias High Warning Setting
• Bias Low Warning Setting • Tx Power High Alarm Setting
• Tx Power Low Alarm Setting • Tx Power High Warning Setting
• Tx Power Low Warning Setting • Rx Power High Alarm Setting
• Rx Power Low Alarm Setting • Rx Power High Warning Setting
• Rx Power Low Warning Setting
SFP information can be obtained by selecting option 7 from the Port configuration screen.
Page 30