User Manual

ManualsBrandsOMNITRON SYSTEMS ManualsComputers & AccessoriesOmnitron Systems 6100 24-Port 100Mbps Ethernet Switch

Omnitron Systems Technology, Inc. 1

27 Mauchly #201, Irvine, CA 92618 (949) 250-6510 Fax: (949) 250-6514

Document #040-06000-002

FlexSwitch

600X

16/24 Port 10/100 Auto-Sensing

Dual Speed Ethernet Switch

User’s Manual

12 Omnitron Systems Technology, Inc.

Summary of content (6 pages)

PAGE 1
2 Omnitron Systems Technology, Inc. Omnitron Systems Technology, Inc.
PAGE 2
Omnitron Systems Technology, Inc. SAFETY CONSIDERATIONS Omnitron OmnitronSystems SystemsTechnology, Technology,Inc. Inc. 1111 TECHNICAL SUPPORT Warning The operating description in this Instruction Manual is for use by qualified personnel only. To avoid electrical shock, do not perform any servicing of this unit other than that contained in the operating instructions, unless you are qualified and certified to do so by Omnitron Systems Technology, Inc.
PAGE 3
10 Omnitron Systems Technology, Inc. Omnitron Systems Technology, Inc. Application 2. Switched Low-Cost Fiber Backbone 3 FlexSwitchTM 600X 10/100 Auto-Sensing Ethernet Switch This application depicts a fiber backbone utilizing a 10/100 UTP switch (A) and several chassis-based (B) and stand-alone media converters. In this case the UTP lines are converted into fiber and connected to Fast Ethernet stations (C), a Fast Ethernet hub (D) and a Fast Ethernet switch (E).
PAGE 4
Omnitron Systems Technology, Inc. The FlexSwitch provides a special uplink feature on the Port 1 RJ45 connector. This uplink connector is equipped with a crossover switch that can switch between the receiving and transmitting wire pairs. This eliminates the need for a “crossed cable” which is otherwise required for a connection to another switch or to a hub. The fiber and UTP uplink modules provide displays to show data speed, link and activity, half/full duplex status and collisions.
PAGE 5
8 Omnitron Systems Technology, Inc. Port Configuration via the Port Management Serial Interface (All Ports) The FlexSwitch 600X has the ability to force ports to a particular speed (10 or 100 Mbps) or duplex (half/full-duplex) through the use of a serial interface. The serial interface is located on the rear of the FlexSwitch 600X and has the ability to configure all ports on the chassis via ASCII terminal or terminal emulator.
PAGE 6
Omnitron Systems Technology, Inc. SITE PREPARATION The following is the minimal physical location preparations needed: 1. Power - A power outlet should be available within 5 feet of the unit. 2. Cabling - The following cabling should be used: a. 10Base-T / UTP - Ideally the site should be cabled with category 5 wiring to maximize performance but a category 3 or better is acceptable (100 ohms, 24 AWG solid copper). b.