User manual
00026389.DOC, Version 1.1
26/31
Group fader
W
ith the group fader, you can adjust the signal level of the group signal. This signal is routed to the GROUP
OUT-sockets or can be routed to the Main Mix fader by pressing the G1-2/L-R-switch.
5.3 Effect-section
0
0
0
0
+
15
+15
+15
+15
-
-
-
-
DIGITALEFFECTPROCESSING
EFFLEVEL
A
UXRETURN
AUXSEND
SEND/EFF
FEEDBACK
ECHO
100ms
125ms
25ms
50ms
75ms
150ms
1
75ms
200ms
0ms
SEND/EFF-SWITCH
With the Send/Eff-switch, you can route the AUX-signal either to the internal effector (pressed position) or to
the AUX SEND-sockets (unpressed position).
ECHO SELECTOR
For selecting the desired echo length.
EFF LEVEL
With the EFF LEVEL-control, you can adjust the signal level of the effect generator.
FEEDBACK-CONTROL
For adjusting the repeat frequency of the echo.
5.4 Power-section
RIGHT
LEFT
SPEAKER
VOLTAGESELECTOR
115V 230V
POWER
ACIN
www.omnitronic.com
®
®
OMNITRONICSHOWEQUIPMENTGmbH,GERMANY
Type: OMNITRONICLS-822A
Powersupply: 115/230VAC,50/60Hz
Powerconsumption: 800W
Fuse230V: T6A,250V
Fuse115V: T12A,250V
~
CAUTION
!
R
ead user manual before use. Keep away from moisture! Disconnect from mains
bef
ore changing fuse. Replace the fuse only with the same type and rating.
Never open the housing! There are no serviceable parts inside the device.
Maintenance and service operations only by authorized dealers.
Vor Gebrauch Anleitung lesen. Gerät vorFeuchtigkeit schützen! Vor Sicherungswechsel
v
om Netz trennen! Nur Sicherungen mit gleichen Leistungswerten einsetzen. Niemals
das
Gerät öffnen! Im Geräteinnern befinden sich keine zu wartenden Teile.
Wartungs- und Servicearbeiten nur durch autorisierten Fachhandel!
Lire le mode d'emploi avant l'utilisation. Ne pas exposer à l'humidité. Débrancher avant
de
remplacer le fusible. Utiliser un fusible de rechange de même type. Ne jamais ouvrir
le boîtier! L'intérieur de l'appareil ne contient pas de parties nécessitant
un
entretien. L'entretien et les réparations seulement par un revendeur autorisé!
POWER SWITCH
Press this button to start operation.
SPEAKER-OUTPUT SOCKETS
For connecting the speakers of channel 1 and 2.