User manual

00026389.DOC, Version 1.1

30/31

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.

Before replacing the fuse, unplug mains lead.

rocedure:

Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.

Step 2: Remove the old fuse from the fuseholder.

Step 3: Install the new fuse in the fuseholder.

Step 4: Replace the fuseholder in the housing.

Should you need any spare parts, please use genuine parts.

If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply

cable available at your dealer.

Should you have further questions, please contact your dealer.

9. TECHNICAL SPECIFICATIONS

LS-622A LS-822A

Power supply: 220-250 V AC, 50 Hz ~ 220-250 V AC, 50 Hz ~

or 110-120 V AC, 60 Hz ~ 110-120 V AC, 60 Hz ~

Power consumption: 500 W 800 W

Inputs:

2/4 mono XLR or balanced ¼" jacks XLR or balanced ¼" jacks

2/4 inserts ¼" jacks ¼" jacks

2 stereo balanced ¼" jacks balanced ¼" jacks

1 Aux-Return balanced ¼" jacks balanced ¼" jack

Tape In RCA RCA

Outputs:

1 Main Mix Out XLR or balanced ¼" jacks XLR or balanced ¼" jacks

1 Headphones balanced ¼" jack balanced ¼" jack

1 Aux-Send balanced ¼" jack balanced ¼" jack

2/4 Direct Out ¼" jacks ¼" jacks

Tape Out RCA RCA

Frequency range:

Microphone: 10 Hz - 60 kHz, ±3 dB 10 Hz - 60 kHz, ±3 dB

Mono: 10 Hz - 60 kHz, ±3 dB 10 Hz - 60 kHz, ±3 dB

Stereo: 10 Hz - 55 kHz, ±3 dB 10 Hz - 55 kHz, ±3 dB

Distortion: 0.01 % 0.01 %

S/N-ratio: 112 dB 112 dB

Tone control/channel:

Treble: ±15 dB at 12 KHz ±15 dB at 12 KHz

Middle: ±15 dB at 2.5 KHz ±15 dB at 2.5 KHz

Bass: ±15 dB at 80 Hz ±15 dB at 80 Hz

Power output sine:

Stereo 4 Ohms 2 x 150 W 2 x 200 W

Dimensions (WxDxH): 330 x 390 x 125 mm 390 x 390 x 150 mm

Weight: 9.5 kg 10 kg

Fuse 230 V: T 3 A, 250 V T 6 A, 250 V

Fuse 115 V: T 6 A, 250 V T 12 A, 250 V