User`s manual

00032561.DOC, Version 1.2
22/32
Adjust the level with the gain-control CH-1 on the front panel.
Choosing appropriate connection cables
The speaker-system must only be connected via a sufficiently dimensioned cable. Too thin cables lead to
cable heatup or enormous power loss and loss in sound-quality.
For all speaker-systems up to 400 Watts, we recommend a cable diameter of 2.5 mm², for all other speaker-
cables 4 mm².
A high damping factor of your amplifier supplies a clear sound reproduction. Unnecessarily long and thin
cables will influence the damping factor and thus the low frequencies in a negative way. In order to
safeguard good sound quality, the damping factor should lie around 50. The longer a cable has to be, the
thicker it should be.
In this respect, a damping factor of 200 will be reduced to 47 (8 Ohms) when using a 10 m long, 2.5 mm²
speaker cable. The power loss at 8 Ohms is 1.63 %, at 4 Ohms 3.25 % and at 2 Ohms even 6.5 %.
The maximum cable length is 30 meters!
Connections
Your speaker-system is equipped with 4-pole, lockable Speaker-sockets. For locking the connection turn the
plug to the right. For unlocking pull the unlock button and turn the plug to the left and pull it out of the socket.
Connection Speaker-socket
INSTALLATION
This speaker-system must only be installed at a solid, plane, anti-slip, vibration-free, oscillation-free and fire-
resistant location.
For speaker-systems with felt cover: the speaker-system is covered with resonance damping felt. This felt is
easily flammable. When choosing the installation area, make sure that no heat like glowing cigarettes, open
fire, heaters etc. can inflame the speaker-system. In order to avoid damage and fire hazard we recommend
to install the speaker-system out of the reach of people.
Before installing the system, make sure that the installation area can hold a minimum point load of 5 times
the system's load (e.g. weight 20 kg - point load 100 kg).
The speaker-system must never be installed higher than 100 cm without secondary attachment.
Install the desired number of speaker-systems in the room.