User manual

00046891.DOC, Version 2.0
17/20
21 Channel faders
Level controls for channel 1-5.
22 Time control for the talkover function
A
djusts the attenuation response time in case o
f
microphone announcements.
23 Power indicator
Lights up when the EM-550 is powered on.
19 Output level controls
Control BOOTH for the booth output and controls OUT 1
OUT 2 for the master outputs 1 and 2.
20 Buttons CUE
Buttons for prefader listening of the input channels 1-5
ahead of the respective channel fader via headphones.
With the button pressed, the LED lights to immediately
indicate that the channel is monitored.
30 Master outputs 1,2
Stereo outputs (optionally bal. 3-pin XLR or unbal. RCA)
for master channels 1 and 2 for connecting an amplifier o
r
other units with line level inputs (e.g. a further mixer,
active speakers).
31 Output BOOTH
• Stereo output (RCA) for connecting a further amplifier, e.g.
for the monitoring system or PA application in a secondar
y
room.
• With the corresponding selector switch the output can
be switched to mono operation.
32 Recording output REC
Stereo output (RCA) for connecting a recording unit. The
recording level is independent of the position of the
output level controls.
33 Power on/off
Press this button to turn the unit on and off. When powered
on, the power indicator on the front panel lights up.
34 Selector switch STERO/MONO
Switches the output BOOTH between stereo and mono
operation.
35 Level selector switch
Switches the level at the master outputs between 0.75 V
and 1.5 V.
24 AC input
Plug in the mains cable of the supplied power unit here
and fix it with the union nut.
25 Gain controls
Trimming controls for adjusting the input amplification o
f
channel 1-5 (from right to left).
26 Inputs PHONO/AUX 1,2
• Stereo inputs (RCA) for channels 1 and channel 2 fo
r
connecting turntables with magnetic system.
• With the corresponding input selector switches the
inputs can be switched to line level.
27 Selector switch for the recording output REC
Switches the microphone channels MIC 1 and MIC 2 at
the output REC on and off:
• Upper position WITH MIC: recordings with microphone
signals
• Lower position NO MIC: recordings without microphone
signals
28 GND (ground terminals)
Ground clamping screws for turntables connected to
channel 1 and channel 2.
29 Inputs LINE 1-8
Stereo inputs LINE (RCA) for channel 1 to 5 fo
r
connecting units with line level outputs (e. g. CD player).