User`s manual

KPA_SERIES_ACTIVE_V_1_1.DOC
32/35
Suitable TV-pin: EUROLITE TV-35 TV-pin for speakers, No. 60000735
Installation of the speaker-system
Caution: The loads have to be installed in a balanced way.
C
aution: The carrying capacity of the stand or speaker stand must never be exceeded!
Install the speaker-system via the flange on the speaker stand or via the TV-pin on the stand.
Make sure that the maximum lifting height of the tube is never exceeded.
Lifted telescopic tubes always have to be secured with a secondary securing!
Installation on a wall-mounting
The speaker-system may only be installed on a wall-mounting if the original speaker-system is equipped with
an appropriate flange.
Suitable wall-mountings:
Wall-mounting for Speakers w. flange No. 60004610
Wall-mounting XY for Speakers w. flange No. 60004620
When installed on a wall-mounting, the speaker-system must always be secured with a safety-rope.
Before attaching the speaker-system, make sure that the
installation area can hold a minimum point load of 10 times the
installation's weight (e.g. 13 kg weight - 130 kg point load).
The durability of the installation depends very much on the material
used at the installation area (building material) such as wood,
concrete, gas concrete, brick etc. This is why the fixing material
must be chosen to suit the wall material. Always ask a specialist for
the correct plug/screw combination indicating the maximum load
and the building material.
The wall-mounting must always be installed via all fixation holes.
Do only use appropriate screws and make sure that the screws are
properly connected with the ground.
A safety rope which already hold the strain of a crash or which is
defective must not be used again.
The speaker-system must always be secured via an appropriate
eye-bolt.
Appropriate eye-bolts:
Eye-bolt M8 No. 30001165
Procedure:
Step 1: On the wall-mounting, there are 4 holes for the installation.
Step 2: Hold the wall-mounting onto the location where it is to be installed.