User`s manual
Table Of Contents
- EINFÜHRUNG
- SICHERHEITSHINWEISE
- BESTIMMUNGSGEMÄßE VERWENDUNG
- RECHTLICHE HINWEISE
- GERÄTEBESCHREIBUNG
- INBETRIEBNAHME
- INSTALLATION
- BEDIENUNG
- REINIGUNG UND WARTUNG
- TECHNISCHE DATEN
- INTRODUCTION
- SAFETY INSTRUCTIONS
- OPERATING DETERMINATIONS
- LEGAL INSTRUCTIONS
- DESCRIPTION OF THE DEVICE
- START-UP
- INSTALLATION
- OPERATION
- CLEANING AND MAINTENANCE
- TECHNICAL SPECIFICATIONS
KPA_SERIES_ACTIVE_V_1_1.DOC
33/35
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the wall-mounting in the desired position and tighten the screws.
Step 6: Insert the eye-bolt into one of the threaded holes. Turn the eye-bolt till stop position.
Step 7: Install the speaker-system on the wall-mounting.
Step 8: Install the safety-rope in the wall-mounting’s safety eyelet and pull it throught the eye-bolt at the
s
peaker-system.
The wall mounting's maximum service life must never be exceeded.
Suspended installation
This speaker-system must never be suspended - Danger to Life due to crashing
speaker-systems!
OPERATION
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin International
Brown Live L
Blue Neutral N
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Switch the device on. After switching on the speaker-system, wait 8 to 10 seconds until you turn the volume-
control in order to avoid speaker-damage.
Caution! Increase the level of each channel only so far that the CLIP-LED lights up shortly. Thus, you avoid
that the output signal is distorted and your speakers are damaged.
When operating the speaker-system, please make sure that the loudspeakers always sound well. When
distorsions can be heard, either the amplifier or the loudspeaker is overloaded. Overloads can quickly lead to
amplifier or speaker damage.
In order to avoid damage, please reduce the volume immediately when distortions can be heard. When
speaker-systems are destroyed by overload, the guarantee becomes void.
Always check the sound pressure level with a meter in order to keep to the threshold.
If you want to switch off the system, switch off the speaker-system first in order to avoid acoustic shocks
on the speakers.