Operating Manual

5. Installation

1. Take the individual parts out of the packaging. Place the full-body applica-

tor on a stable, even surface, such as on the oor, on a couch or under the

mattress (but not box-spring mattresses) of your bed (pay attention to the

intensity adjustment, please). Heavily shaped and soft furniture, such as a

sofa, chair, very soft surfaces should be avoided, since the pressure load on

uneven supports may lead to damage to the built-in copper coils.

2. Aside from this, make sure that your environment is as free of electro-smog

as possible. There should not be any devices like: TVs, microwave ovens, ra-

dio-based telephones and so forth in the immediate vicinity (approx. 1-2m)

during an application.

3. Connect one of the supplied applicators to the Omnium1 control device as

follows:

• Connect the supplied D/A converter with the 20-pin ribbon cable

• Connect the second plug attached to the 20-pin ribbon cable with the

corresponding connection on the Omnium1

(see the Omnium1 operating

manual)

• Connect the desired applicator with the D/A Converter.

4. Make sure that battery for your Omnium1 has been suciently charged.

The application will not be possible if the battery charge state drops below

5%. In that case, connect the power supply with the Omnium1

(see the

Omnium1 operating manual)

5. Check the system time selected (upper right) and set it to the current time,

if necessary

(see the Omnium1 operating manual)

. The built-in organ clock

will adjust automatically to this system clock during an application.

5.1 Installing / removing the battery

To install the battery, open the rear battery cover, connect the plug to the

connector on the tablet, place the battery in the compartment and close the

cover.

To remove the battery, open the rear battery cover, pull out the battery, dis-

connect the cable and close the cover.