Operating Manual
19
10.2 Factory Settings
By tapping the “Reset Factory Settings” button, you can restore the iMRS one
app to its delivery state.
Note: all of the stored users will be deleted.
10.3 Users
See Chapter 7, Saving and Loading Pre-set Parameters.
11. Updating
Whenever your Omnium1 is connected to the internet (via WIFI), your iMRS
one App automatically veries, whether a new software version is available. In
this case a notication appears on your screen. Please klick on „YES“ followed
by clicking on „Install“. The System will automatically update the App to the
newest version.
12. Applicators
Three applicators are available for selection for the iMRS one app.
12.1 OmniMat
The full body mat (OmniMat) delivers a 100% analog, pulsating, electromag-
netic eld exposure for the entire body while lying on the applicator. Three
solid copper coil pairs with a different number of windings (intensity) have
been built into the full body applicator. The copper coil pair at the head (cable
connected to the applicator box) has the lowest number of windings and
thereby generates the lowest ux density. The middle pair of copper coils has
an already higher number of windings and the bottom pair of coils (at the foot)
has the highest number of windings with the high ux density.
The full body applicator is divided by seams. It can be folded into three parts
on the seams, however should not be bent or rolled in order to protect the
copper coils.
The full body applicator has been covered with certied articial leather. The
magnetic eld not only works directly above the full body applicator, but also
spreads itself out in all directions. The eld strength amounts to less than or
equal to 45 μT (micro-teslas) at the highest intensity setting on the full body