Manualshelf

Datasheet

ManualsBrandsOmron Electronic Components ManualsDevelopment Boards & KitsCable Harness for Sensor Evaluation Board 500mm
12345678910
2JCIE-EV
8
Jumper Function (Power Related)
• When using an external power supply, remove the zero-ohm resistance from JP1 and connect the zero-ohm resistance to JP2 ((1) below).
Connect the power of the external power supply to the V terminal in (2) below, and connect GND to G.
• (2JCIE-EV01-AR1/FT1 only) When using an external battery, connect the battery to B and GND to G. When using a battery, a 5 V input sensor
cannot be used.
• When you switch to JP2, JP1 is disabled and power cannot be supplied from the platform board.
• Do not connect JP1 and JP2 at the same time.
How to switch by jumper
• Remove the zero-ohm resistance from JP1 by soldering arm and mount the JP2 by soldering. (Do not connect by soldering while connected to
a base board or to an external power source)
Jumper Function (Output Terminal)
When connected, the above function is enabled. When open, the above function is disabled.
JP5 and JP6 are paired and cannot both be enabled.
How to switch by jumper
Cut the JP6 connection location (central part) with cutters, and connect the divided parts of JP5 by soldering.
Note: Give full consideration to safety when cutting the jumper. OMRON cannot bear responsibility for any injury or damage that occurs.
Accessories
Note: To connect this board to the corresponding platform, it must be directly soldered or the pin header or socket must be soldered.
No. Positions Meaning Application Default Status
JP1
Front Zero-ohm resistance
When supplying power from the platform board Connected Enabled
JP2
When power is supplied from an external power supply or battery
(Only the 2JCIE-EV01-AR1/FT1 supports batteries)
Open Disabled
No. Positions Meaning Application Default Status
JP5
Back
(2JCIE-EV01-AR1/FT1 only)
Switch by board pattern
For TH1 expansion Open Disabled
JP6 B5W digital output function Connected Enabled
Type Model
Pin socket for 2JCIE-EV01-RP1 ESQ-120-12-L-D (SAMTEC)
Pin header for 2JCIE-EV01-AR1 TSW-114-07-L-S (SAMTEC)
Pin socket for 2JCIE-EV01-FT1
ESQ-112-12-L-S (SAMTEC)
ESQ-116-12-L-S (SAMTEC)
(1)
(2)
2JCIE-EV01-FT1 Layout