Datasheet

B3W-9B3W-9
Removing the Cap
1. Hold the cap at the side away from the mating section. Pull
straight up.
2. Do not remove the cap while the Switch is mounted. Doing
so will apply force to the soldered section and LEDs, result-
ing in malfunction.
Placing the Cap on the Switch
Hold the Cap at the side away from the mating section. Push
straight down until the mating section meets.
Removing the Cap
The Cap can be removed up to two times. Excessively removing
the Cap will cause the mating section to become weak, resulting
the operating section not mating completely or the Cap may fall
off.
Film Dimensions
Dimensions of the film are shown below. The thickness is 0.2 mm.
Storage Precautions
Storage Environment
To prevent degradation, such as discoloration, of the terminals
during storage, do not store the Switch in locations that are sub-
ject to the following conditions.
1. High temperature or humidity
2. Corrosive gases
3. Direct sunlight
Storage condition
Store the Switches in the packaging box.
After the packaging box is opened, use the contents as quickly as
possible. When storing leftover parts, make sure that appropriate
measures are taken against humidity and corrosive gases.
Agreement of Product Use
Comply with the usage, storage, and disposal conditions speci-
fied by OMRON as outlined in the precautions in the product
datasheet and specifications.
Correct Incorrect
Correct Incorrect
7.4±0.1
8.9±0.1
8.9±0.1
7.4±0.1
In the interest of product improvement, specifications are subject to change without notice.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. A167-E1-04
OMRON Corporation
Electronic Components Company
Switch Division
Manual Switch Department
Shiokoji Horikawa, Shimogyo-ku,
Kyoto, 600-8530 Japan
Tel: [phone]/Fax: [phone]
0509