Datasheet
5
C3AW Trigger switch for DC Brushless tools
Using Switches
• When switches are actually used, unforeseen accidents may
occur. Before using a switch, perform all possible testing in
advance.
• Unless otherwise specified, ratings and performances given in
this catalog are for standard test conditions (i.e., +5 to +35°C,
and +45% to +85% humidity). When performing testing in the
actual application, always use the same conditions as will be
used in actual usage conditions for both the load and the oper-
ating environment.
• Reference data provided in this catalog represents actual
measurements from production samples in graph form. All ref-
erence data values are nominal.
• All ratings and performance values provided in this catalog are
the results of a single test each rating and performance value
therefore may not be met for composite conditions.
• Output voltage changes due to the brush sliding along the top
surface of the circuit board in the switch. When there is contact
resistance between the circuit board and the brush, it goes into
a state of high impedance, and the output voltage fluctuates.
To prevent this from happening, a pull-up/down circuit can be
implemented.
Check the level of output voltage fluctuations and compatibility
of this circuit with your application to determine if this switch
fits your needs.
Precautions for Correct Use
Voltage
Stroke
Exampleofoutputvoltage
fluctuations