Datasheet

675

Text

674

Text Subminiature Basic Switch (Sealed) – D2SW

ALL DIMENSIONS SHOWN ARE IN MILLIMETRES.

To convert millimetres into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.

Sealed Microswitches

CAT. No. C097-E2-01D

Using Micro Loads



Using a model for ordinary loads to open or close the contact of

a miroload circuit may result in faulty contact. Use models that

operate in the following range. However, even when using micro

load models within the operating range shown below, if inrush

current occurs when the contact is opened or closed, it may

increase contact wear and so decrease durability. Therefore,

insert a contact protection circuit where necessary.

The minimum applicable load is the N-level refreence value. This

value indicates the malfunction reference level for the reliability

level of 60% (

60). The equation,

60 = 0.5 x 10-6/operations

indicates that the estimated malfunction rate is less than

1/2,000,000 operations with a reliability level of 60%.

Subminiature Basic Switch (Sealed) – D2SW

Note: AV 0.5f wires are used for

standard lead wire model.

UL1015 AWG22 wires are used

for UL/CSA approved models

Omron 08 Cat 565-773 5/10/07 15:58 Page 674