Manualshelf

Datasheet

ManualsBrandsOmron Electronic Components ManualsMiscellaneous Sensor AccessoriesSensor Wire Harness, 1m, Omron EE-SX
12
60 EE-SX3009-P1/-SX4009-P1 Photomicrosensor (Transmissive)
Photomicrosensor (Transmissive)
EE-SX3009-P1/-SX4009-P1
■ Dimensions
Note: All units are in millimeters unless otherwise indicated.
■ Features
• Screw-mounting model.
• High resolution with a 0.5-mm-wide sensing aperture.
• With a 5-mm-wide groove.
• Photo IC output signals directly connect with C-MOS and TTL.
• Connects to Tyco Electronics AMP’s EI-series connectors.
• Dark ON model (EE-SX3009-P1)
• Light ON model (EE-SX4009-P1)
■ Absolute Maximum Ratings (Ta = 25°C)
Note: Refer to the temperature rating chart if the ambient tempera-
ture exceeds 25°C.
■ Electrical and Optical Characteristics (Ta = 25°C, Vcc = 5 V ±10%)
Internal Circuit
Dimensions Tolerance
4 mm max.
±0.2
4 < mm ≤ 16
±0.3
16 < mm ≤ 63
±0.5
Terminal No. Name
V Power supply
(Vcc)
O Output (OUT)
G Ground (GND)
V
G
O
Recommended Mating Connectors:
Tyco Electronics AMP 171822-3 (crimp connector)
172142-3 (crimp connector)
OMRON EE-1005 (with harness)
Optical
axis
171825-3
(Tyco Electronics AMP)
3±0.1 dia, depth: 2
0.5 (Aperture width)
Two, R1
4.2±0.2 dia. hole
4
0
−0.1
dia.
34
23±0.2
10.5
7.5
Unless otherwise specified, the
tolerances are as shown below.
Item Symbol Rated value
Power supply voltage V
CC
10 V
Output voltage V
OUT
28 V
Output current I
OUT
16 mA
Permissible output dissipation P
OUT
250 mW
(see note)
Ambient temper-
ature
Operating Topr –25°C to 75°C
Storage Tstg –40°C to 85°C
Soldering temperature Tsol ---
Item Symbol Value Condition
Current consumption I
CC
30 mA max. With and without incident
Low-level output voltage V
OL
0.3 V max. I
OUT
= 16 mA
Without incident (EE-SX3009-P1)
With incident (EE-SX4009-P1)
High-level output voltage V
OH
(V
CC
x 0.9) V min. V
OUT
= V
CC
With incident (EE-SX3009-P1)
Without incident (EE-SX4009-P1), R
L
= 47 kΩ
Response frequency f3 kHz min. V
OUT
= V
CC
, R
L
= 47 kΩ (see note)
Note: The value of the response frequency is measured by
rotating the disk as shown below.
2.1 mm
0.5 mm
0.5 mm
t = 0.2 mm
Disk
Be sure to read Precautions on page 24.

Summary of content (2 pages)