Datasheet

G5NB PCB Power Relay

■Precautions

●Please refer to “PCB Relays Common Precautions” for correct use.

●Coil Voltage Reduction (Holding Voltage) after Relay

Operation

• If the coil voltage is reduced to the holding voltage after Relay

operation, first apply the rated voltage to the coil for at least

100 ms, as shown below.

• A voltage of at least 40% of the rated voltage is required for

the coil holding voltage. Do not allow voltage fluctuations to

cause the coil holding voltage to fall below this level.

* The coil resistance were measured at a coil temperature of 23°C with

tolerances of ± 10%.

Correct Use

Applied

coil voltage

Coil resistance*

Power

consumption

Rated voltage 100%

125Ω (5 VDC)

720Ω (12 VDC)

2880Ω (24 VDC)

Approx. 200 mW

Holding voltage 40% Approx. 32 mW

40%

(Holding voltage)

100%

(Rated voltage)

100ms min.

Please check each region's Terms & Conditions by region website.

OMRON Corporation

Electronic and Mechanical Components Company

Regional Contact

Cat. No. J143-E1-12

0719(0207)(O)

Americas Europe

https://www.components.omron.com/ http://components.omron.eu/

Asia-Pacific China

https://ecb.omron.com.sg/ https://www.ecb.omron.com.cn/

Korea Japan

https://www.omron-ecb.co.kr/ https://www.omron.co.jp/ecb/

In the interest of product improvement, specifications are subject to change without notice.