Datasheet

CP1L
22
Expansion I/O Unit Specifications
■ CP1W-40EDR/40EDT/40EDT1/32ER/32ET/32ET1/20EDR1/20EDT/20EDT1/16ER/16ET/16ET1/8ED/8ER/8ET/8ET1 Expansion I/O Units
Expansion I/O Units can be connected to the CPU Unit to configure the required number of I/O points.
● DC Inputs (CP1W-40EDR/40EDT/40EDT1/20EDR1/20EDT/20EDT1/8ED)
● Relay Outputs (CP1W-40EDR/32ER/20EDR1/16ER/8ER)
Item Specifications
Input voltage 24 VDC +10%/−15%
Note: 1. Do not apply a voltage exceeding the rated voltage to an input terminal.
2.
Can be set in the PLC Setup to 0, 0.5, 1, 2, 4, 8, 16 or 32 ms. The CP1W-
40EDR/EDT/EDT1 are fixed at 16 ms.
1ms min. (hardware delay value)
Input impedance 4.7 kΩ
Input current 5 mA typical
ON voltage 14.4 VDC min.
OFF voltage 5.0 VDC max.
ON delay 0 to 32 ms max. (Default: 8 ms) (See note 1.)
OFF delay 0 to 32 ms max. (Default: 8 ms) (See note 1.)
Circuit configuration
Item Specifications
Max. switching capacity 2 A, 250 VAC (cosφ = 1), 24 VDC 4 A/common
Min. switching capacity 5 VDC, 10 mA
Service
life of
relay
Elec-
trical
Resistive
load
150,000 operations (24 VDC)
Inductive
load
100,000 operations (24 VAC cos = 0.4)
Mechanical 20,000,000 operations
ON delay 15 ms max.
OFF delay 15 ms max.
Circuit configuration
Internal
circuits
IN
IN
COM
4.7 kΩ
750 Ω
Input LED
Note: There are restrictions in the power supply voltage and output load current
imposed by the ambient temperature for CPU Units with DC power.
Use the CPU Unit within the following ranges of power supply voltage and
output load current.
Refer to the CP1L CPU Unit Operation Manual (Cat. No. W462) or the CP
Series CP1L-EL/EM CPU Unit Operation Manual (Cat. No. W516).
Internal
circuits
L
L
OUT
OUT
COM
Output LED
Maximum
250 VAC: 2 A,
24 VDC: 2 A
CP1L.fm 22 ページ ２０１２年３月１９日 月曜日 午後１時１８分