Datasheet

E32
E32
106
Installation
J S E NSING HEAD
Mounting Sensing Head in a Panel
Prepare a hole in the panel that can accommodate the threaded
cylindrical sensing head. Be sure to place the washer in front of
the mounting nut before inserting the sensing head through the
hole. Tighten the front mounting nut using no more than the
maxi mum torque recommended in the table.
Spring mountingclip
Toothed washers
Nuts
(attachment)
Mounting Sensing Head in a Channel
Insert the sensing head at the desired location i n the channel as
shown in the illustration, then use a set screw to fasten the head
in place. Appl y no more than 2.6 in-lb of force in tightening the
set screw.
Retaining screw
(M 3 max.)
Tightening Torque
Use a proper-si zed
wrench and do not
exceed the torque
recommended for the
sensing head.
Sensing heads Maximum torque
M3 and M4 threads
M6 threads
6.88 in-lb
8.66 in-lb
2 mm dia., no thread
3 mm dia., no thread
2.6 in-lb
2.6 in-lb
E32-D14L
E32-T12F
8.66 in-lb
6.88 in-lb
E32-D12F
E32-T16
6.88 in-lb
4.33 in-lb
E32-R21
E32-M21
E32-L25A
5.2 in-lb
4.33 in-lb
6.88 in-lb
J CUTTING FIBER
Insert a fiber into the Fiber and determine the length of the fiber
to be cut.
Press down the Fiber Cutter in a single stroke to cut the fiber.
When the fiber is cut, an insertion mark is inscri bed on the fiber.
12.6
Insertion mark
2.2-dia.
For a 2.2-mm dia. standard fiber only.
Insert a fiber into the Fiber Cutter in the direction indicated by the
arrow (refer to the following figure).
1
2
The cutting holes cannot be used twice. If the same hole is used
twice, the cutting face of the fiber will be rough and the sensing
distance will be reduced. Al ways use an unused hol e.
Use ei ther one of the two holes on the right (refer to the foll owing
figure) to cut a thin fiber as follows:
1. An attachment is temporarily fitted to a thin fiber before
shipment.
Temporarily fitted
2. Secure the attachment after adj usting the position of it in the
direction indicated by the arrow.
3. Insert the fiber into the E39-F4 to cut.
Three holes for
standard fiber
(2.2 mm dia.)
Cutter E39-F4
Two holes for
thin fiber
Note: Insert the fiber in the direction indicated by the arrow.