Datasheet

E32
E32
J SPECIAL HANDLING
E32-D51/-T51 Heat-Resistant Fiber
The bending radius of the fibers should be 35 mm min.
Connecting fi bers via the E39-F10 Fi ber Connector is not
possible.
The withstand temperature of the H eat-Resistant Fibers is 150°C
max. In continuous operation, the ambient temperature should be
130°Cmax.
E32-T14/-T51
If the sensor is ON because some object i n front of the lenses
reflects light, attach the black seals (sold together) to the lenses.
E32-T14/-G14
Seal
E32-L25 (A) Wafer Sensor
Insert the fiber with a white line i nto the light projection side of the
Amplifier.
The tightening force of the sensor head is 8 kgf S cm (0.75 N S m).
Avoid places where water could be sprayed onto the E32-L25(A).
E32-T16 Slit Seal (Attachment)
Peel the E32-T16 Sl it Seal off the ground paper and affix the Sli t
Seal to the sensing face of the sensor so that the corners of the
Sl it Seal fit in with the corners of the sensing face. To sense an
object at a distance of 30 cm max., a 0.5-mm wide S lit Seal must
be used.
E32-T16 Sensing Head
Attachment slit
Cat. No. CEDSAX4 11/01 Specifications subject to change without notice. Printed in U.S.A.
OMRON ELECTRONICS LLC
One East Commerce Drive
Schaumburg, IL 60173
NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches divide by 25.4.
1-800-55-OMRON
OMRON CANADA, INC.
885 Milner Avenue
Scarborough, Ontario M1B 5V8
416-286-6465
R
OMRON ON--LINE
Global -- http://www.omron.com
USA -- http://www.omron.com/oei
Canada -- http://www.omron.com/oci