Datasheet

Frequency/Rate Meter K3MA-F 11

Installation

1. Insert the K3MA-F into the panel cut-out hole.

2. For a waterproof installation, insert the rubber gasket onto the

body of the K3MA-F.

3. Fit the adaptor into the grooves on the left and right sides of the

rear case, then push it until it contacts the panel to secure the

K3MA-F.

■ Wiring Precautions

• Use crimp terminals.

• Tighten the terminal screws to a torque of approximately 0.5 N

⋅m.

• To avoid the influence of noise, route signal lines and power lines

separately.

■ Wiring

• Use the following M3 crimp terminals.

■ Unit Labels (Provided)

• The unit labels are not attached to the K3MA-F. Select the desired

labels from the provided sheet.

Note: For scales and gauges, use the unit labels that are specified by

the relevant laws or regulations.

5.8 mm max.